Hi to everybody,
I would to know if is it possible to change, during defect recording, the sample size.
Example:
1. Inbound form PO of 100 pz
2. Creation of inspection lot of 5 (in based on sample scheme definition)
3. Quality inspection steps in QA32: - Inspection results -> Inspected : 5 result: 1 (there is a defect)
At the time in which I found a defect, i would to change, for the same inspection lot, the quantity to check. In this way the lot size must be changed form 5 to 10 pz inspected.
Is it possibile?
Tks and regards,
Peter