Hi all;
I know there's a lot of info on this subject but I'm still a bit confused re regarding the functionality.
Please assist me with the following 2 questions:
1) I can't find the setting "SPRO>Quality Management>Quality Inspection>Make settings for Copy of Inspection Results" in SAP.
We're using ECC6 Mill solution EHP6. Could this be the problem or must it be activated from support packs (tcode SFW5)?
2) I have a basic requirement to copy adhoc from one inspection lot to another.
The normal business process caters for a MES system to send results to SAP using QM IDI.
On a very rare occasion we will need to populate an inspection lot with manual results (i.e. for some reason MES will be unable to supply results for the specific insp lot).
Since the inspection lot contains +/- 100 characs, it's easier to copy from a similar lot after which one or two results can be tweaked.
Is it possible to use the functionality behind "Make settings for Copy of Inspection Results" for these adhoc requests, while still maintaining the current functionality for the remaining 99%?
Any other solution/ideas would be highly appreciated.
Thank you kindly.
Regards
W