Hi Experts,
As per client requirement, I have mapped Inspection points for In-process inspection. Inspection characteristic are assigned to operation of routing.
whenever user record the results, auto valuation should happen based on results for each MIC's.
I have made the setting as below :-
At plant level in Customisation maintain the following
1) Plant level - Result Recording
2) Inspection point field combination : FR1( customised as per requirement)
3) partial Lot Assign : Partial lot for each inspection point
4) Proposal for inspection point valuation : Maintain any of the selected set coded you have created for 03 inspection or 04 inspection( WHEN THIS IS USE, I GUES AT THE TIME OF UD??)
5) Recording configuration - No background function
Master Data Required
1) Maintain 03 inspection in MM02
2) Selected set for 03 inspection for the particalur plant
3) Sampling procedure with selection of inspection point as this mandatory
4) Sampling type - Fixed sample
5) Valuation mode - Attributive Inspection nonconf.units
6) Inspection Pts - Free inspection pts
7) Sample size -1
8) MIC are Qualitative
9) Control Indicators - Sampling procedure checked, Summ. recording checked, required char checked, Fixed scope checked, RR changes docs checked,
ROUTING
1) Go to CA02
2) go to header
3) Maintain inspection Point as FR1( Customised use to capture serial number)
4) Maintain partial Lot Assign as partial lot for each inspection point
5) At Operation level maintain a NO QM work center with Control key QM04.
6) double click on the control key and go to Quality Management : Inspection points
7) Maintain Inspection point completion : AUTOMATIC VALUATION BASED ON INSP. POINT DEFINITION
8) DONT WANT TO CREATE INSP POINTS AT TIME INTERVAL AND QUANTITY BASED.
9) Soo NO RELATION radio button selected.
10) Selection the QM operation and maintain in the MIC with above said sampling procedure
At transaction level
1) create order co01, release and save . lot will be created.
2) Do the opertion confirmation if there is any operation mentioned in the routing before the qm operation
3) go to qa32.> result > you will get a pop of all the operation with yellow traingle mentioning QM is active in that operation. double click on the QM operation
4) pop will come for entering SERIAL NUMBER AS I HAVE DEFINE INSPECTION POINTS AS SERIAL NUMBER>
When recording the results for each characteristic, its should auto valuate. but in this case it is not happening? Dont know why.
Do we required to confirm the operation use for Inspection characteristics.
Auto UD for inprocess Inspection, Is it possible??
Thanks
Babar